Lesson 3 of 4 · 11 min
Equipment, and the checks that matter
Most equipment failures are not mechanical. They are set-up.
Do not operate handling equipment you have not been trained and signed off on. This lesson describes what the checks are for; it does not qualify you to use anything.
What this is about
Hoists, slide sheets, transfer belts, standing machines, shower chairs and beds each have their own trained use. The common failures are the same across all of them: brakes, fit, and clear space.
Slings are the one worth being most careful about. The wrong size, the wrong loop, or a sling from a different manufacturer to the hoist can all fail in ways that are not obvious until the person is off the ground. Slings are person-specific for a reason.
Equipment that is damaged, overdue for service, or missing its tag should be taken out of use and reported, not worked around. A hoist with a sticky brake is a hazard even if it has worked every time so far.
Key ideas
- Brakes on, floor clear, and the route planned before anything moves
- Slings are matched to the person and the hoist — never swap them around
- Check for damage: fraying, worn stitching, cracked plastic, a low battery
- Faulty equipment is tagged out and reported, not used gently
- Tell the person what is about to happen before you move them, every time
What this looks like in practice
- Checking sling stitching and loops before every use, not just when something looks wrong
- Making sure the wheelchair is braked and positioned before the person leaves the bed
- Reporting a hoist with a flat battery instead of using the manual emergency lower routinely
Think it through
You go to use a hoist and notice the sling's stitching is frayed along one of the leg straps. The shift is short-staffed and this is the only sling of that size on the floor. What do you do?
Choose the answer you think fits best. You will see why for each option.
Try this on your next shift
Next time you use a sling, look at the label: check the size, the maximum load and that it matches the hoist.
Your reflection
Is there a piece of equipment at your workplace everybody knows is not quite right? What has stopped it being reported?
Your employer's policies, your role description and your supervisor decide what you may do. If this module describes something your workplace does differently, or something you have not been trained and authorised to do, follow your workplace and ask your supervisor.
Check your answer to the scenario question to finish this lesson.
This is not accredited training, a qualification, a licence or a CPD certificate.